FAQ

This equipment has been designed to generate, by conduction and necessarily supported by forced ventilation, ozone in quantities and volumes indicated as per model, in order to disinfect and deodorize the emission air of a facility not connected to the outdoor environment.

This equipment has been designed to be installed on pipelines with forced ventilation emitting outdoors.
The equipment must have the same diameter of the pipeline where it is going to be installed and can admit a flow reduction, but not any clearance inside the pipeline.
Once the equipment is installed on the appropriate pipeline, YOU HAVE TO CONNECT THE PLATE INCLUDED ON THE EQUIPMENT PACKAGE ON THE PLUG TO THE POWER TRANSFORMER
WARNING: PLATE MUST ALWAYS BE CONNECTED WITH THE EQUIPMENT OFF

No preventive servicing operations are required. It is advisable to check periodically there is no obstruction on the ventilation ducts and that the forced ventilation works properly.

This equipment has been designed for use with an exterior exhaust, not for facilities with people or animals. When the ozone levels are above 200 micrograms/m3 on the facility, entering the facility must be done with the appropriate protection measures, as it could have an irritant effect.

DO NOT CHANGE THE PLACE WITHOUT CONSULTING WITH THE QUALIFIED TECHNICIAN
DO NOT INSTALL IN FACILITIES WHERE VOLATILE CHEMICALS ARE MANIPULATED
OZONE MIGHT BE IRRITANT AT INMISSION LEVELS HIGHER THAN THE ONES INDICATED ON THIS MANUAL
THE OZONE GENERATOR MUST BE KEPT REFRIGERATED AT ALL TIMES
THE OZONE GENERATOR SHOULD BE KEPT OFF AT LEAST DURING 30 MINUTES AFTER EACH STOP
DO NOT TOUCH THE PLATE WHILE IN USE, DANGER OF HIGH VOLTAGE AND BURNS
KEEP OUT OF REACH BY CHILDREN
OPTIMAL WORKING TIME FRAME OF THE PLATES IS ESTIMATED BETWEEN 14-18 MONTHS
WAIT ABOUT 30 SECONDS FOR THE NEW TOTAL START OF THE PLATES

The product: ODOR INHIBITOR WITH OZONE – OZONE GENERATOR TYPE B is standard UNE 400-201-94 compliant. Product patent # ES1139516